-
Recent Posts
- Effects Of Barrel Length | Shotgun Report® January 27, 2023
- The Truth About Light Loads | Shotgun Report® January 26, 2023
- Parker Restoration And Rebarreling | Shotgun Report® January 25, 2023
- Kolar or Briley | Shotgun Report® January 24, 2023
- Sporting Clays/Trap Gun | Shotgun Report® January 23, 2023
- Miroku MK38 Trap January 20, 2023
- Custom Shotgun Stock (ft. Jim Greenwood) January 19, 2023
- 3 Invaluable Lessons January 18, 2023
- Decoying Essex Pigeons January 17, 2023
- Beretta Victoria Line January 13, 2023
Recent Comments
- jim on Sporting Clays/Trap Gun
- Russell Wadsworth on Browning Gold 3-1/2″ Problems
- Monty Bridges on Barrel In The Periphery
- Bill E. on Beretta Custom Shop
- Dave Goddard on The Classic Cutts Compensator
- Kenneth Discepolo on Hard Kicking 686
- Bill E. on Jonny Visits Beretta-Part 1
- joe on The Classic Cutts Compensator
- Tom Fiumarello on Butt plates – hard or soft?
- blackwellopt on Jonny @ 2022 US Nationals
Categories
Archives
Meta
-
Join 293 other subscribers
Tag Archives: point of impact
Testing Point Of Impact
Dear Technoid: Does it make any sense to use slugs to check for point of impact? Shooting a few slugs at a target is certainly quicker and easier than shooting a number of shotshells at pattern sheets then guestimating the … Continue reading →
Point Of Impact And Choke Tube Pressure
Bruce: After reading your response and before a pre dinner pop I relaxed to the cogistative state about the subject. The dim bulb in this old head lighted up and I went again to the pattering board. After thinking about … Continue reading →
Moving Point Of Impact
Technoid: Went to the pattern board today. Im right handed, I had a sx3 20ga 26 in barrel with 14 in LOP an a CZ 20ga auto with a 14 1/2 LOP 28 in barrel, shot two differnt loads 1oz … Continue reading →
Sporting POI And Extended Chokes
Dear Technoid, Following your advice, I recently purchased a Browning 425 in 30″. My gun has a factory adjustable comb. I shot it to point of impact and at 30 yards with mod choke, the pattern is well centered but … Continue reading →
Raising Point Of Impact
Dear Bruce, I recently purchased a Beretta 686 O/U in 12ga. I patterned the gun using the figure 8 bead alignment and found that the POI was exactly at the POA, a 50/50 or at least close enough to be … Continue reading →