Tag Archives: Shotgun

Raising Point Of Impact


Dear Bruce, I recently purchased a Beretta 686 O/U in 12ga.  I patterned the gun using the figure 8 bead alignment and found that the POI was exactly at the POA, a 50/50 or at least close enough to be … Continue reading

Posted in Shotgun related | Tagged , , | Leave a comment

Pre-Mounted Gun


Dear Bruce, I have been shooting low gun for both skeet and sporting clays for the last several years. I learned the fundamentals from Keith Lupton, and have never held high mount since then except for an occasional round of … Continue reading

Posted in Shotgun related | Tagged , | Leave a comment

A Fitting Comment


Your Majestic Benevolence, After years of shooting (practicing mistakes), I have empirically determined that a longer length of pull is best for the gun down position. A parallel, long stock may be ideal but the problem is I pumped iron … Continue reading

Posted in Shotgun related | Tagged , , | Leave a comment

Shooting In Argentina


Dear Bruce, My friend and I are wanting to go to Argentina this year and I would like to know if you would Have a guide you would recommend? I have sent for info and they all say the same … Continue reading

Posted in Shotgun related | Tagged , , , | 2 Comments

SxS for Clays


Hi Bruce, Henry N. sic’ed me on you for some advice on SxS’s. I’m looking to buy a SxS for shooting clays games.  I have shot SxS’s quite a bit and find them no added challenge, and I really enjoy … Continue reading

Posted in Shotguns | Tagged , , , | 6 Comments

The Truth About Light Loads


Technoid: Appearing on the web is the unrefuted comment, to wit: “Back in the old days of International Trap 1.25oz. loads were allowed and when they went to 1.125 oz. loads to lower the scores nothing happened. Then they went … Continue reading

Posted in Shotgun related | Tagged , , , | Leave a comment

Kolar or Briley


Dear Dr. Gauss, I’m plan to purchase tubes (3 gauge set) for a Beretta 687. Kolar or Briley? I’m having a difficulty getting the facts of the differences. Second, will I need a spring “job” for the .410 trigger ($65) … Continue reading

Posted in Shotgun related | Tagged , , | 1 Comment